And be sure you label which fuse goes to what on the provided page to leave inside the box. Be sure to disconnect both shore power and your house battery before you work on the converter. There are good instructions and it is not difficult.
If you don’t mind dealing with lots of wires (label them) you can do it yourself. We purchased ours from where Randy was helpful with advice (he sells both the WFCO and the PD upgrades).
Pop up camper converter upgrade#
Progressive Dynamics Upgrade to Magnetek includes new 12 volt fuse board fits into original box and uses original circuit breakers You will have extra fuse positions available so you can add more 12 VDC circuits if desired (we added three, 12 VDC outlets). All the upgrade kits offer filtered power for all the 12 volt circuits, unlike the original Magnetek. We bought the PD4600 that was the recommended upgrade for our model of Magnetek. WFCO and Progressive Dynamics both make upgrade kits to the Magnetek. You could replace the entire converter, but the easy solution is one of the upgrades that use the original RV Magnetek converter box and circuit breakers (for the 120 VAC side) yet replace the guts and the fuse board (12 VDC side). The solution is an upgrade to your old converter to add a three-stage charger. We believe some later model Magneteks did have two-stage charging. The maker tried to pick a middle of the road charging level, but the result is bad at both ends. If you have gel or AGM batteries you may avoid the mess and you can’t add water, but it will shorten the life of your batteries. Also, if you leave your camper plugged in for too many days, it will likely “boil” (overcharge) your batteries, meaning not only making a mess, but also requiring you add distilled water often (if you have a standard wet cell batteries). Why? It is a very simple single-stage charger. The problem is that if you have a low battery and plug into shore power that Magnetek can take several days to fully recharge your battery. The Magnetek was the choice of many RV manufacturers for years. Magnetek Converter / Charger box – twist black plastic square latch at top to open (Red switch is solar cut-off) The battery charger for your house battery is built into your converter or your inverter, depending on what the RV manufacturer choose to install. There is a loss in doing this - it is always better when running off batteries to run 12 VDC appliances rather than using 120 VAC appliances on an inverter - your batteries will last longer. An inverter takes 12 VDC and “inverts” it to 120 VAC.
Pop up camper converter generator#
For those not familiar with the differences, a converter takes 120 VAC (volts alternating current – like in your house) from either plugging into shore power or from your generator and “converts” it to 12 VDC (volts direct current - like your car battery).
Your fuses and circuit breakers will be inside the cover of the converter box. Magneteks are very common in the RV world. If you have an older Roadtrek or many other older RVs you likely have a Magnetek Converter/Charger (newer Roadtreks have inverter/chargers like the Tripplite).
0 kommentar(er)
